0-856-01 Durite 12V Modified Wave Voltage Inverter - 125W

 Durite 0-856-01 12 Volts DC 125W modified wave voltage inverter.

• Input: 12V to 15V DC.
• Output: 230VAC 50Hz.
• Rated 125 watts, continuous.
• Quiescent (inactive) current less than 0.25A.

Protection Against

• Overload.
• Over-temperature.
• Low battery.
• High input voltage.
• Short circuit.

Supplied With

• A standard 3-Pin socket outlet.
• On-Off switch.
• Cigarette lighter plug and cable.

Dimensions

• Length: 240mm.
• Width: 138mm.
• Height: 76mm.

Warnings for Translation

• Read all instructions before attempting to install or use the inverter.
• High voltage, 230 Volts AC, is generated by this unit.
• Do not use it with wet hands or near water.
• This unit is only suitable for 12 Volts electrical systems with negative earth.
• To supply 230 Volts 50 Hz loads of < 125 Watts.
• Do not connect to any other AC power source.

Installation Instructions

 It is recommended that the inverter is fixed to a suitable surface whenever possible. The site chosen should be:

• Well-ventilated.
• Not exposed to direct sunlight or heat source.
• Away from water or moisture.
• Out of reach of children.
• Away from any flammable or heat-sensitive substance.

Operating Instructions

1. Ensure that the inverter is supplied by a 12-14 Volts DC negative earth system and that the load requires <125 Watts at 230 Volts 50Hz AC.
2. Plug the inverter into a cigarette lighter socket and push the plug firmly into the socket to ensure good contact. The supply to the socket should be correctly fused. If the fuse blows before the maximum inverter output is reached, do not replace the fuse with a larger fuse, you will have to ‘hard’ wire the inverter using a suitable fused supply.
3. Plug the appliance into the inverter and then turn on the inverter’s power switch. The LED will illuminate to indicate AC power is present, then switch on the appliance.
4. Unplug the inverter when not in use.
5. Switch off the inverter when heavy current is drawn from the DC supply, e.g. when starting an engine from the same supply source.

Troubleshooting

 If the inverter beeps or does not appear to be functioning properly, check the following:

1. Low DC supply voltage, supply voltage <10.5 ± 0.5 Volts.
2. Low DC voltage shutdown, supply voltage <10.0 ± 0.5 Volts.
3. Overload shutdown, check load requirement is <125 Watts.
4. Thermal shutdown, switch off, allow the inverter to cool down and reduce load.
5. Wiring, terminals and connections.

Specifications