0-856-02 Durite 12V Modified Wave Voltage Inverter - 250W

 Durite 0-856-02, 12VDC 125W modified wave voltage inverter.

• Input: 10V to 15V DC.
• Output: 230VAC 50Hz.
• Rated at 250 Watts, continuous.
• Quiescent (inactive) current less than 0.65A.

Protection Against

• Overload.
• Over-temperature.
• Low battery.
• High input voltage.
• Short circuit.

Supplied With

• A standard 3-Pin socket outlet.
• On-Off switch.

Dimensions

• Length: 240mm.
• Width: 158mm.
• Height: 76mm.

Warnings for Translation

• Read all instructions before attempting to install or use the inverter.
• High voltage, 230 Volts AC, is generated by this unit.
• Do not use it with wet hands or near water.
• This unit is only suitable for 12 Volts DC electrical systems with negative earth.
• To supply 230 Volts 50 Hz loads of < 250 Watts.
• Do not connect to any other AC power source.

Installation Instructions

 Disconnect all battery leads, -ve leads first, before installing the inverter.

 Locate a suitable position for the inverter and fit it securely. The site chosen should be:

• Well ventilated.
• Not exposed to direct sunlight or heat source.
• Away from water or moisture.
• Out of reach of children.
• Away from any flammable or heat-sensitive substance.

 Connect the Black 12 Volts -ve terminal to the negative side of the supply source and the Red 12 Volts +ve terminal to a fused positive supply source. Use a minimum of 4.50mm² cable and keep all cable runs as short as possible.

Operating Instructions

1. Ensure that the inverter is supplied by a 12-14 Volts DC negative earth system and that the load requires <250 Watts at 230 Volts 50Hz AC.
2. Plug the appliance into the inverter and then turn on the inverter’s power switch. The LED will illuminate to indicate AC power is present, then switch on the appliance. Always turn on the inverter before turning on the load.
3. Switch off the inverter when not in use or when heavy current is drawn from the DC supply, e.g. when starting an engine from the same supply source.
4. If the inverter beeps but is still supplying AC output, this indicates a low supply voltage; switch off the inverter to preserve battery voltage. If left on, the inverter will automatically shut down when the supply voltage falls to approximately 10.0 ± 0.5 Volts.

Troubleshooting

 If the inverter beeps or does not appear to be functioning properly, check the following:

1. Low DC supply voltage, supply voltage <10 .5 ± 0.5 Volts.
2. Low DC voltage shutdown, supply voltage <10.0 ± 0.5 Volts.
3. Overload shutdown, check load requirement is <250 Watts.
4. Thermal shutdown, switch off, allow the inverter to cool down and reduce load.
5. Wiring, terminals and connections.

Specifications