0-523-73 Durite 24V Illuminated Water Temperature Gauge 52mm Diameter

 Durite 0-523-73, 24 Volts DC illuminated water temperature gauge for vehicle dashboards and panels.

• Voltage: 24VDC.
• 90° sweep.
• Supplied with ¹⁄₈″ NPTF sender.
• Matt black bezel and white figures.
• Requires 52mm dashboard hole.
• Bridge type fitting.

Associated Product

• ¹⁄₈″ NPTF replacement sender available separate, part number: 0-523-93.

Fitting Instructions for Translation Purposes

1. Ensure that the gauge voltage matches the vehicle or system voltage.
2. Ensure that the system has cooled down before starting work to avoid scalds and burns.
3. Switch off the ignition and remove the key. Disconnect the battery (earth terminal first).​ Note: Before disconnecting the battery, make sure all system start-up codes are known, i.e. coded radios, etc.
4. Choose a suitable location for the gauge with adequate access to the rear of the gauge for connections and fixings.
5. Cut a 53mm diameter hole at the chosen location for the gauge. Push the gauge into the hole and fit the “U” bracket over the mounting studs at the rear of the gauge. Fit washer(s) and nut to each stud. Align gauge and tighten nuts.
6. Fit the sender unit to a suitable point in the system being monitored. Ensure that the sender unit body connects to the Earth.
7. Connect the terminal marked “+” to a suitable ignition-controlled fused supply or positive feed and connect the terminal marked ”-” to earth or negative feed. Connect the terminal marked “S” to the stud terminal on the sender unit.
8. Connect the bulb wiring, orange wire to the vehicle panel lamp supply (after the fuse) and black wire to earth.
9. Check all connections are correct and secure. Reconnect battery (earth terminal last). Start the engine and check that the gauge registers. Switch on the panel lamps and check that the gauge is illuminated. Check the system for leaks!