0-525-32 Durite Marine 12V-24V LED Lit Water Level Gauge Without Sender

 Durite 0-525-32, marine-styled 12 or 24 Volts DC LED illuminated water level gauge. Supplied without a sender unit due to differing lengths.

• Voltage: 12-24VDC
• 90° sweep dial.
• Supplied without sender, available part numbers to order are listed below.
• Plastic cased.
• LED illumination choice of White or Yellow
• Matt black bezel and white figures.
• Requires 52mm dashboard hole.
• Large screw collar type fitting.

Pole Tank Sender Part Numbers

• 0-525-92: 250mm deep.
• 0-525-93: 290mm deep.
• 0-525-94: 350mm deep.
• 0-525-95: 500mm deep.
• 0-525-96: 600mm deep.

Wiring

1. Black – to Common Ground (-)
2. Red – to Positive (+)
3. Green – to the sensor unit
4. White – for the White backlight (+)
5. Orange – for the Yellow backlight (+)

Fitting Instructions

1. Cut a 52mm (2 1/16 inch) diameter panel hole.
2. Save a minimum of 55mm (2 3/16 inches) depth behind the panel to fit the gauge.
3. Remove the fastening ring.
4. Fit cables through the panel hole and insert the connector into the back of the gauge.
5. Insert the gauge through the panel from the front, fit and tighten the fastening ring from the rear, checking the position of the gauge before tightening.
6. Connect cables by following the instructions.

Specifications