0-525-26 Durite Marine 12V-24V LED Illuminated Fuel Level Gauge

 Durite marine-styled 12V-24V LED illuminated fuel level gauge, supplied without a sender unit due to differing lengths.

• 90-degree sweep dial.
• Supplied without pole tank sender (part numbers are below).
• Plastic cased.
• Matt black bezel and white figures.
• Requires 52mm dashboard hole.
• Large screw collar type fitting.

Wiring

1. Black - to Common Ground (-)
2. Red - to Positive (+)
3. Green - to the sensor unit
4. White - for the White backlight (+)
5. Orange - for the Yellow backlight (+)

Fitting Instructions

1. Cut a 52mm (2 1/16 inch) diameter panel hole.
2. Save a minimum of 55mm (2 3/16 inches) depth behind the panel to fit the gauge.
3. Remove the fastening ring.
4. Fit cables through the panel hole and insert the connector into the back of the gauge.
5. Insert the gauge through the panel from the front, fit and tighten the fastening ring from the rear, checking the gauge's position before tightening.
6. Connect cables by following the instructions.

Pole Tank Sender Part Numbers

• 0-525-92: 250mm deep.
• 0-525-93: 290mm deep.
• 0-525-94: 350mm deep.
• 0-525-95: 500mm deep.
• 0-525-96: 600mm deep.

Specifications