SW202N-254 Albright Double-acting Motor-reversing Solenoid 12V Intermittent

 Albright SW202N-254 250 Amps double-acting 12VDC strapped pair contactor for hydraulic motor switching, intermittent coil.

• Paired and linked 12 Volts DC single-pole, double-throw (SPDT) switch solenoids.
• The SW202 series of contactors has been designed for direct current loads, particularly motors used on small electric vehicles such as industrial trucks, warehouse forklifts, airport tractors, etc.
• The contactors are compact and fully serviceable, with various spare parts available.
• Repair contact kit part number: 2155-136.
• Without magnetic blowouts.
• Enclosed top covers fitted.
• No bracket is supplied or fitted.
• Diode and resistor fitted to the coils.
• Brass locknuts fitted onto Normally Open (NO) terminals.
• No hardware (nuts and bolts) fitted to the Normally Closed (NC) terminals

Associated Products

• 2155-202 Auxiliary switch kit (1 kit does 1 x coil).
• 2155-136 Repair contact kit.
• 2155-165 Albright Large Solenoid L-Shape mounting bracket.
• 2155-56 Albright SW202 Solenoid mounting bracket

Dimensions

• Height, including terminals and coil base cap: 152mm.
• Assembly width, including bars and bracket: 160.5mm.
• Cap width: 2 x 48mm.
• Total depth, including bracket: 82mm.

About The Intermittent SW202-254 Reversing Contactors

 Intermittent contactors, by design, are predominantly used for hydraulic functions on vehicles; they switch quicker than continuous solenoids and are not recommended for prolonged contact periods.

 The SW202 is a configuration of two 'Single Pole, Double Throw' type contactors on a common bracket for motor reversing. The SW202 features single pole double-breaking main contacts with Silver-alloy tips, which are weld resistant, hardwearing and have excellent conductivity.

 The SW202 main contact circuit, designed for motor reversing, is such that it has a built-in failsafe so that if both coils are energised simultaneously, the contact arrangement is open circuits.

 The SW202 has M10 stud main terminals and 6.3mm spade coil connections. Mounted using the supplied bracket, mounting of the solenoids can be horizontal or vertical. When vertical, the M10 contact studs should point upwards.

Specifications