SW201-48 Albright 36V Single-pole Double-throw Solenoid Contactor - Intermittent

 SW201-48 single-pole, double-throw solenoid contactor 36 Volts DC intermittent.

• The SW201 has been designed for 36V direct current (DC) loads, including motors as used on electric vehicles such as industrial trucks.
• Developed for both interrupted and uninterrupted loads, the SW201 is suitable for switching Resistive, Capacitive and Inductive loads.

Associated Products

• 2155-250 Albright SW201 Series Contact Kit.
• 2155-202 Auxiliary Micro-Switch Kit for Largest Albright Contactor Caps.
• 2065-167A Albright Solenoid Mounting Bracket.
• 2155-165 Albright Large Solenoid L-Shape Mounting Bracket.
• 2028-551A Albright Solenoid Mounting Bracket

Magnetic Blowouts

 These contactors are fitted with magnetic blowouts across the contact gaps as standard. These enable high currents to be ruptured very quickly so that arcing time is reduced to a minimum. Fitting of blowouts can make the contacts polarity sensitive and the positive markings on the top cover of the contactor must be observed.

About Intermittent (INT) SW201-48 Solenoids

 Intermittent contactors by design are predominantly used for hydraulic functions on vehicles, they make and break quicker than continuous solenoids and are not recommended for prolonged contact periods.

 The SW201 has M10 stud main terminals and 6.3mm spade coil connections. It can be mounted via M5 tapped holes or mounting brackets purchased as separate items. Mounting can be horizontal or vertical, when vertical the M10 contact studs should point upwards. Please note Normally Closed contacts are not suited to make and break load.

Specifications