SW181B-2 Albright 12V Single-pole Double-throw Solenoid Contactor - Continuous

 Albright SW181B-2 single-pole, double-throw 12Vdc solenoid contactor, continuous.

• The SW181B-2 has been designed for 12V direct current (DC) loads, including motors as used on electric vehicles such as industrial trucks.
• Developed for both interrupted and uninterrupted loads, the SW181 is suitable for switching Resistive, Capacitive and Inductive loads.

Associated Products

• 2180-43 Albright SW181 Series Contact Kit
• 2180-43A Albright SW181L Series Contact Kit - Large Tips
• 2180-796 Auxiliary Micro-Switch for Larger Albright SW Range Contactor Caps
• 2159-47 Mounting Bracket.
• 2155-165 Mounting bracket.
• 2065-167A Mounting bracket.

Magnetic Blowouts

 These contactors are fitted with magnetic blowouts (denoted by the 'B' suffix in the SW181B range) across contact gaps. These enable high currents to be ruptured very quickly so that arcing time is reduced to a minimum. The fitting of blowouts can make the contacts polarity sensitive and the positive markings on the top cover of the contactor must be observed.

About Continuous (CO.) SW181B-2 Solenoids

 Continuous contactors by design are predominantly for drive functions on vehicles, they have weaker coils, switch slightly slower than intermittent solenoids and are recommended for prolonged contact periods.

 The SW181 has M8 stud main terminals and 6.3mm spade coil connections. It can be mounted via M5 tapped holes or mounting brackets purchased as separate items. Mounting can be horizontal or vertical, when vertical the M8 contact studs should point upwards. Please note Normally Closed contacts are not suited to make and break the load.

Specifications