HV500F-149 Albright 24VDC High Voltage Contactor - Intermittent

 Albright International HV500F-149 24VDC 'Normally Open' solenoid contactor, intermittent.

• 24 Volts DC single-pole, single-throw (SPST) contactor with flying leads.
• These contactors are primarily for use with Direct Current (DC) or Alternating Current (AC) loads via the main stud terminals. The coils are switched with a Direct Current only.
• Intermittent coil with unpopulated PCB board fitted. I.E., no PWM circuit.
• Customers should have their own PWM (Pulse Width Modulation) control.
• A Black Terminal Guard is fitted, protecting the main terminals from accidental contact.
• Initial Operating current: 2A

Applications for Types of HV500 Contactors Include

• Automotive - Vehicle and Charging
• Battery Management Systems
• Power Distribution Units
• Renewable Energy

Dimensions

• Height, including terminals and coil base: 71mm.
• Coil width, including base: 81mm.

About the Intermittent (Int.) HV500 Solenoids

 Intermittent contactors, by design, are predominantly used for hydraulic functions on vehicles; they make and break quicker than continuous solenoids and are not recommended for prolonged contact periods.

 Hermetic Sealing: The Albright HV range is fully hermetically sealed, allowing durability in extreme environments or when operating in potentially hazardous conditions.

 Mounting is through a rotatable bracket which offers 6 angles for orientation. This allows for complete flexibility with the position of main contacts, allowing for customer ease of connection. Recommended panel mounting tightening torque is 2.5Nm to 3Nm.

Specifications