DC66-125P Albright 12V DC Motor-reversing Solenoid Continuous 80A IP66

 Albright DC66-125P 12VDC 80 Amps motor-reversing switch solenoid, continuous.

• The DC66P range of compact 80A contactors follows the established design of the SW60 mono-block contactors, which are configured specifically for motor reversing.
• The DC66P is ideally suitable for use with small battery-powered winches, vehicle-mounted cranes, small electric vehicles, etc.
• These contactors have closed contact housings and are sealed to inhibit the ingress of moisture or other contamination, they can, therefore, be used in environments that require protection to IP66.
• All the contactors are manufactured to a very high standard and employ the best quality materials: phenolic contact housings, Silver-alloy contacts and class H (180℃) winding wire for the coils.
• Repair kits are not available for this unit.
• Stainless steel hardware specification including bracket, screws, nuts and groovers.

Dimensions

• Height including terminals and coil base cap: 87.9mm.
• Width: 63.9mm.
• Depth (including bracket): 47.15mm.

Additional Information

 Continuous contactors by design are predominantly used for drive functions on vehicles, they make and break slower than intermittent solenoids and are recommended for prolonged contact periods.

 The main contact circuit has a built-in fail-safe, so that if both coils are energised simultaneously the contact arrangement is an open circuit. The DC66P has double-breaking main contacts with Silver-alloy tips, which are weld resistant, hardwearing and have excellent conductivity. The DC66P has M6 main stud terminals and coil connections are by means of 6.3mm spades.

Specifications