0-775-65A Durite 12V CCTV IR Side Mount 1080P Colour Camera

  Durite 0-775-65A 12 Volts DC 1080p AHD Side Camera with 1/2.8” SONY CMOS IMX307. Supports both Normal/Mirror Image.

• Voltage: 12V DC.
• 1/2.8” SONY CMOS IMX307.
• Supports both Normal/Mirror Image.
• 4 PIN Aviation Connector.
• 5 IR LEDs.
• Protected to IP69K.
• Audio.
• E Marked EMC R10, ECE R26 compliant housing.

Dimensions

• Length: 67.4mm.
• Width: 50.9mm
• Height: 44mm.

Mirror Vs. Normal Image

• The camera default image is NORMAL image.
• There is a ‘jumper’ included with the camera.
• If MIRROR image viewing is required please disconnect the jumper from the applicable connection on the camera flying lead.
• Disconnect then reconnect the power to the camera for the setting change to take place.

Warnings for translation purposes

 Before using this unit, please read these instructions carefully. Take special care to follow the warnings and safety suggestions listed below. Keep these instructions for future reference. There are no user-serviceable parts within the unit; refer servicing to qualified service personnel.

Precautions

• Please ensure you are familiar and comply with local traffic and driving regulations.
• Connection - The camera should only be connected to a Durite cctv system.
• Heat - Do not install the camera near heat sources.
• Mounting - Ensure the camera is facing the desired direction before fixing the camerabase. If fixing to isolated return chassis the camera bracket should be isolated from thevehicle chassis.
• Service - The user should not attempt to service these units beyond that described in theseinstructions. All other servicing should be referred to an authorised service technician.
• Fixture - Do not over tighten camera housing/cover to base plate screws. Recommended torque setting for tightening is 0.45-0.55Nm.

General Information

• The camera has a CMOS image sensor, which gives a high-quality picture, and its solid-state circuitry provides an extremely long life.
• Compact size and single connection make it easy to install.
• Automatic gain control (AGC) provides a clear image in both strong sunlight and low light conditions.
• It is recommended that all camera lead connections are additionally sealed by either wrapping with a suitable tape or applying heat shrink sleeving.
• It is recommend to connect the system and test before fixing to ensure the correct field of view is displayed.

Specifications