0-450-90 Durite Butane Micro Blow Torch

 Durite 0-450-90 mini blow torch for soldering on terminals, heat shrinking of terminals and heat shrink sleeving.

• Refillable torch from standard butane gas lighter fuel.
• Child-resistant (CR auto-reset safety lock).
• Flame operating temperature at 900°C.
• CE approved.

Features

• Micro Torch with Aluminium Diamond Cut Metal Handle.
• Piezo auto-ignition.
• Child-resistant (CR auto-reset safety lock).
• Continuous button.
• Adjustable hard and soft flames.
• Meets BS, US CPSC and CE Safety Standard and Certification and 26258.
• For compliance with ISO 9994: 2005 lighters safety specification .

Dimensions

• Length: 11cm
• Width: 6.5cm
• Height: 15cm

Warnings for Translation Purposes

 Before using this unit please read these instructions carefully. Take special care to follow the warnings and safety suggestions listed below. Keep these instructions for future reference.

General Warnings

• Contains flammable gas under pressure.
• Never puncture or put in fire.
• Use only Butane lighter fuel.
• Do not use an appliance which shows any damage.
• Close the taps, valves, adjusted knobs of the appliance before connection or refill.
• Refill the tank in a well-ventilated place, in a flame or ignition source free atmosphere, far from other persons.
• Do not smoke while refilling.
• Do not put an ignited appliance down.
• Refilling by an inadequate method may lead to serious accidents.
• Verify that seals if any at the connection are well placed and not damaged.
• Check the hoses for damage.
• Do not work in enclosed space, maintain good ventilation.
• Work only in a clean place, far from combustible or greased materials.
• Wear eye-protection and gloves for handling hot appliances.
• Avoid breathing welding / soldering fumes.
• Allow the appliance to cool down before storing.
• Store and transport the containers upright.
• Use only specified spare parts.
• Never try to repair a damaged tool.
• Do not throw the appliance or the container into fire.
• Avoid contact of flux with skin and eyes.
• Always have a fire extinguisher and a bucket of water near the torch and work area.
• Do not touch the exhaust port with metal or any hard item.
• Do not store in temperatures over 120F(49C) (Such as in a car in hot weather).
• After using the micro torch, the safety lock should be engaged.
• Do not point the flame directly at any person.
• Be careful when using the micro torch in bright light because the flame is not very visible.

Ignition and Extinguishing

• Rotate the Air Adjustment Ring to fully expose the air holes.
• Press the Child Safety Switch which will release the C/R mechanism; then push the Trigger which will automatically ignite the torch.
• After ignition, sliding the Continuous Flame Switch to right will keep a continuous flame.
• Sliding the Continuous Flame Switch to left will extinguish the flame.

Flame Adjustment

• Turn the Flow Control Adjuster to “+” or “-” for flame length adjustment.
• Rotate the Air Adjustment Ring to change the flame setting.

Refilling Gas

• Refilling by an inadequate method may lead to serious accident.
• Make sure the flame is fully extinguished.
• Refill the micro torch in a well ventilated area away from any source of ignition and away from other persons.
• Do not smoke while replacing or refilling the micro torch.
• Refill with triple refined butane gas only.
• Place the torch in an upside down position.
• Insert the nozzle of the butane canister into the torch Refilling Valve.
• Press down on the canister until the gas starts to overflow.