0-443-43 Durite 12V-24V R65 and R10 5Ft Amber LED Flashing Light Bar

 Durite 0-443-43 5ft (1420mm) Amber LED flashing light bar with 176 SMD LEDs.

• Voltage: 12V/24VDC.
• Maximum power 88W.
• 10 Flash patterns including single and double.
• L x 1420 W x 326 x H 81mm.
• Waterproof to IP67.
• 4 Bolt fixing.
• E-marked, ECE R65 and R10 approved.

Dimensions

• Length: 1420mm
• Width: 326mm
• Height: 81mm (with bracket)

Notes For Consideration

1. Larger wires and tight connections will provide longer service life for components. For high-current wires it is highly recommended that terminal blocks or soldered connections be used with heat shrink tubing to protect the connections. Do not use insulation displacement connectors.
2. Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices to reduce voltage drop. High ambient temperatures (e.g. under hood) will significantly reduce the current carrying capacity of wires, fuses and circuit breakers.
3. Particular attention should be paid to the location and method of making electrical connections and splices to protect these points from corrosion and loss of conductivity.
4. Ground termination should only be made to substantial chassis components, but preferably to the vehicle battery.
5. Circuit breakers are very sensitive to high temperatures and will 'false trip' when mounted in a hot environment or operated close to their capacity.

Wiring Up The Lightbar

1. Route wires from the vehicle positive (battery, alternator, fuse block) to the switch panel in the cab. Use suitable high-temperature vehicle cable if it passes through the engine compartment. Install an 8.9A fuse as close to the point of tapped power as possible.
2. Connect the wires to the positive side of the additional control switch panel with quick-connect terminals or by soldering.
3. After the light bar has been mounted, route the wiring harness into the vehicle to the switch panel location.
4. Connect the wires of the light bar wiring harness to the switched side of each switch. See the wiring diagram for the wire colour key.
5. Connect the light bar cable Black wire (-VE) to a solid ground connection on the vehicle (Ideally, direct to the battery negative terminal).
6. Use cable ties and grommets to secure and protect all cables and wires.

 This unit is a safety device, and it must be connected to its own separate, fused power point to ensure its continued operation should any other electrical accessory fail. Do not wire in parallel with any other accessory. Disconnect the battery before wiring up the light bar to prevent accidental shorting, arcing and/or electrical shock.

Specifications