0-443-32 Durite 12V-24V Premium R65/R10 4-Bolt 2ft Light Bar

 Durite 0-443-32 12 or 24 Volts DC 2ft long Amber LED flashing light bar.

• Voltage 12V-24VDC (10V-30VDC)
• Maximum power 72W
• 19 flash patterns. 72 LEDs.
• E marked EMC R10 ECE R65 approved.
• waterproof to IP65
• 4-bolt fixing.

Dimensions

• Length: 743mm
• Width: 270.6mm
• Height: 98.5mm

Mounting Instructions For Translation Purposes

 Before proceeding with​ the installation, plan all cable and wiring routing. Select the mounting location for the light bar on a flat, smooth surface and centre the unit across the vehicle's width. The mounting location for the lightbar should be chosen so that the lightbar is level and visibility to traffic is optimised. Mounting should be such that there is no less than 12mm (1/2") clearance between the roof and the lightbar at any point.

1. Insert the heads of the M8 mounting bolts into the opening at the end of the slots on the base of the lightbar. Loosely fasten mounting feet to base extrusion using M8 nuts and spring washers (refer to diagram).
2. Determine the location of the lightbar and the best route for wiring.
3. Loosen the M8 nuts to allow the mounting feet to slide along the base. Place the lightbar on the vehicle in the determined location and slide the mounting feet into position. It is suggested that the feet be symmetrical and positioned near the curved edges of the roof, where the roof is the strongest.
4. With the feet positioned, mark the location of the mounting hole centres on the roof. Remove the bar and drill the 8.5mm -10.0mm (11/39") mounting holes as marked. Note the centre distance between the mounting holes in a foot is 135mm (5 5/16").
5. Insert M8 Coach bolts into the mounting feet (refer to diagram) and tighten the M8 nuts holding the feet to the base of the lightbar.
6. Mount the light bar with the bolts going through the holes drilled in step 4, routing the wire as planned in step 2 (refer to diagram). See the wiring section of this manual for further wiring instructions. Install washers and M8 Nyloc nuts, and secure the unit.

Specifications